Getting Started with Seeed Studio XIAO ESP32S3 Series | Seeed Studio Wiki

[giscus[bot]]

Getting Started with Seeed Studio XIAO ESP32S3 Series | Seeed Studio Wiki

Getting Started with Seeed Studio XIAO ESP32S3 Series.

https://wiki.seeedstudio.com/xiao_esp32s3_getting_started/

[Lenigan96]

I have little project and I was wondering... Is it possible to o connect the ESP3253 (Master) with the RA4M1 (slave)?

[nfs0619]

It’s definitely possible to connect the ESP32S3 (master) with the RA4M1 (slave) for communication. However, you'll likely need to design the circuit yourself to match the interfaces and communication protocols between the two. Make sure that both can properly connect and communicate.

[Lenigan96]

I'm getting this error:

Leaving...
Hard resetting with RTC WDT...

A serial exception error occurred: Cannot configure port, something went wrong. Original message: OSError(22, 'The I/O operation has been aborted because of either a thread exit or an application request.', None, 995)
Note: This error originates from pySerial. It is likely not a problem with esptool, but with the hardware connection or drivers.
For troubleshooting steps visit: https://docs.espressif.com/projects/esptool/en/latest/troubleshooting.html
Failed uploading: uploading error: exit status 1