Moving slider to 0 range will change to the 'All' view

[amp7368]

When loading/refreshing the timings report page, the 'count' is lower than it should be, and therefore gives a high % of tick.

When moving the slider of the timings time-range all the way to the right, and then move the slider back to where it was originally, it shows different timings that seem more accurate.

I tested this with a completely blank 1.19.2 server without any plugins and the latest version of paper at the time of writing (286). I'm using google chrome as a browser.

The timings report of the blank server
https://timings.aikar.co/dev/?id=b69fa8da578641eea89026c7195be442

Initial page load

Move the slider to the right

Restore the slider's original position

[electronicboy]

Default view mode is lag, which shows ticks which took too long, rather than all ticks; given jvm warmup, etc, losing a few dozen ticks on startup ks expected; you see that in your view where the count is showing all ticks, you're now in all view

[amp7368]

Oh, I see what happened! Thank you for pointing that out! I didn't notice that it changed the view mode when moving the slider.

To summarize and be make sure we're on the same page:
The default view mode is 'Lag'
Then whenever the slider has a range of 0 included ticks,
the site decides that 'All' mode should be the new view. (without me changing the view mode directly)

I misidentified what the cause of the count change was.
I'm not sure if that is the intended behavior though.
If it is, then we can close this issue now.

I don't think that moving the range slider should impact the view mode at all. I think it's quite confusing.