Lilygo T-Beam Supreme S3 Bricked - Help Please #5799
-
|
I got a Lilygo T-Beam Supreme S3 with Meshtastic 2.3.4 installed yesterday and had it up and running fine. Today, I tried updating the firmware with the web flasher and the unit appears bricked. The web flasher correctly auto-detected the unit on the Com Port and I put it in boot mode and flashed to 2.5.15.79 beta. It ran to 100% and I did a Reset. The only response is a brief flash in the upper left, above the USB C port. Unplugging from USB C power a few minutes and replugging - same brief flash. I tried a full Erase & Install with the same outcome - just a brief blue LED flash. I switched from a Win 11 PC to a Win 10 PC with a hi-quality USB C cable and got the same fail. Do I have any options to fix it? |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
|
NOTE: I fixed this by a manual update vias CLI Script as per https://meshtastic.org/docs/getting-started/flashing-firmware/esp32/cli-script/ |
Beta Was this translation helpful? Give feedback.
NOTE: I fixed this by a manual update vias CLI Script as per https://meshtastic.org/docs/getting-started/flashing-firmware/esp32/cli-script/