Relative Rotary Encoder SENSOR

Specification

What		Comments
Identifier	REL_ROT_ENCODER
Interface	3 GPIO	GPIO 1: A signal GPIO 2: B signal GPIO 3: SW signal (switch)
Provides	dir	-1: counter clockwise 0: no movement 1: clockwise
	val	encoder value
	sw	0: switch released 1: switch pressed
Properties	none
Callbacks?	yes

Notes:

• This sensor requires debouncing by hardware

Code

In this example an encoder is attached at GPIO26 (A), GPIO14 (B) and GPIO21 (SW)

s = sensor.attach("REL_ROT_ENCODER", pio.GPIO26, pio.GPIO14, pio.GPIO21)
s:callback(
   function(magnitude)
      if (magnitude.dir == -1) then
         print("ccw, value "..magnitude.val)
      elseif (magnitude.dir == 1) then
         print("cw, value "..magnitude.val)
      end
      
      if (magnitude.sw == 1) then
         print("sw on")
      elseif (magnitude.sw == 0) then
         print("sw off")
      end
   end
)