Update palm rejection wording

README.md

@@ -120,11 +120,11 @@ The values below can be edited under Info.plist within the kext itself - these c
 | `TrackpointScrollMultiplierY` | 20 | Same as the above, except applied to the Y axis |
 | `TrackpointDeadzone` | 1 | Minimum value at which trackpoint reports will be accepted. This is subtracted from the input of the trackpoint, so setting this extremely high will reduce trackpoint resolution |
 | `MinYDiffThumbDetection` | 200 | Minimum distance between the second lowest and lowest finger in which Minimum Y logic is used to detect the thumb rather than using the z value from the trackpad. Setting this higher means that the thumb must be farther from the other fingers before the y coordinate is used to detect the thumb, rather than using finger area. Keeping this smaller is preferable as finger area logic seems to only be useful when all 4 fingers are grouped together closely, where the thumb is more likely to be pressing down more |
-| `PalmRejectionMaxObjWidth` | 255 | Max contact width before contact is considered accidental. This value will require experimentation as it differs between models. Rehabman's `ioio` is a good application for this. |
-| `PalmRejectionMaxObjHeight` | 255 | Max contact height before contact is considered accidental. This value will require experimentation as it differs between models. Rehabman's `ioio` is a good application for this. |
-| `PalmRejectionWidth` | 10 | Percent (out of 100) width of trackpad which is used for palm rejection on the left and right side of the trackpad |
-| `PalmRejectionWidth` | 60 | Percent (out of 100) height of trackpad which is used for palm rejection on the left and right side of the trackpad (starting from the top) |
-| `PalmRejectionTrackpointHeight` | 20 | Percent (out of 100) height of trackpad which is used for palm rejection across the top of the trackpad |
+| `PalmRejectionMaxObjWidth` | 255 | Max contact width before contact is considered accidental. This value can be acquired by experimentation using Rehabman's `ioio`. |
+| `PalmRejectionMaxObjHeight` | 255 | Max contact height before contact is considered accidental. This value can be acquired by experimentation using Rehabman's `ioio`.  |
+| `PalmRejectionWidth` | 10 | Percent (out of 100) width of trackpad which is used as a low confidence zone on the left and right side of the trackpad |
+| `PalmRejectionWidth` | 60 | Percent (out of 100) height of trackpad which is used as a low confidence zone on the left and right side of the trackpad (starting from the top) |
+| `PalmRejectionTrackpointHeight` | 20 | Percent (out of 100) height of trackpad which is used as a low confidence zone across the top of the trackpad |
 
 Note that you can use Rehabman's ioio to set properties temporarily (until the next reboot).  
 `ioio -s RMIBus ForceTouchType 0`