Intro

• Working in 2024 with TTN V3.
• T-Beam 1.0 in 868MHZ (yes that's an old one).
• Only tested with Platformio in VScode.
• GPS set to 115k baud (must be done with u-center or so).
• TX window, only send if moved at least a configurable distance.
• Auto power off if battery is below a configurable voltage.
• supports OLED display on the I²C interface on GPIO22 and GPI21. This repo contains a patched SSD1306 library from smartnick, enabling individual I²C pins and to set I²C Clock to 800kHz.

This is a simple sketch demonstrating the capability of the TTGO T-Beam as a TTN Mapper Node on The Things Network LoraWAN.

Forked from MichaelEFlip/Lora-TTNMapper-T-Beam from sbiermann/Lora-TTNMapper-ESP32 and with some information/inspiration from cyberman54/ESP32-Paxcounter and Edzelf/LoRa. The forked repo from hottimuc was converted to a PlatformIO project (currently for hardware revision >= 0.8).

Features

• selectable datarate and power (button short press)
• selectable transmit interval (button longer press)
• selectable send-port to enable "on device" switch to experimental mapping (button even loooonger press)
• support for HW-revisions (V08 / V0.8, V09 / V0.9, V10 / V1.0, with soft-power-button and powermanagement chip) (short press = power-on / dimm-mode; long press = power-off)
• supports OLED display on the I²C interface on GPIO22 and GPI21. This repo contains a patched SSD1306 library from smartnick, enabling individual I²C pins and to set I²C Clock to 800kHz.

Software dependencies

PlatformIO

LMIC-Arduino : Make sure to get the last version - 1.5.1 (PlatformIO will take care of this)

Instructions

Copy all from here locally, open it with PlatformIO, rename config.h.template to config.h and fill with your ABP credentials. Then upload it to the T-Beam.

On The Things Network side, the settings needed are available here.

Configuration in The Things Network Console:

• Frequency plan: Europe 863-870 MHz (SF9 for RX2 - recommended) (9or where you are located!)
• LoRaWAN version: LoRaWAN Specification 1.0.2
• Regional Parameters version: RP001 Regional Parameters 1.0.2

Payload uplink formatter type: custom Javascript formatter

function decodeUplink(input) {
	var bytes = input.bytes;
	var decoded = {};

	var latitude = ((bytes[0]<<16)>>>0) + ((bytes[1]<<8)>>>0) + bytes[2];
	latitude = (latitude / 16777215.0 * 180) - 90;

	var longitude = ((bytes[3]<<16)>>>0) + ((bytes[4]<<8)>>>0) + bytes[5];
	longitude = (longitude / 16777215.0 * 360) - 180;

	var altValue = ((bytes[6]<<8)>>>0) + bytes[7];
	var sign = bytes[6] & (1 << 7);
	var altitude;
	if(sign)
	{
		altitude = 0xFFFF0000 | altValue;
	}
	else
	{
		altitude = altValue;
	}

	var hdop = bytes[8] / 10.0;

  return {
    data: {
      latitude:latitude,
      longitude:longitude, 
      altitude:altitude, 
      hdop:hdop 
    },
    warnings: [],
    errors: []
  };
}