NMPS schemes

Combination meter

Connector C-102

Pin number	Pin function
51	Glow indicator lamp
52	Charge warning lamp
53	-
56	Input of turn-signal lamp LH switch
57	Earth
58	-
59	Over drive off indicator
60	A/T fluid temperature warning lamp
61	Oil pressure switch
62	-
63	Check engine warning lamp
64	Water separator indicator lamp

Connector C-103

Pin number	Pin function
31	Shift indicator - L
32	-
33	-
34	Tachometer (engine speed)
35	Speedometer (vehicle speed)
36	Power supply from ignition switch (IG1)
37	Shift indicator - 2
38	Shift indicator - D
39	Shift indicator - N
40	Shift indicator - R
41	Shift indicator - P
42	Battery power supply

Connector C-104

Pin number	Pin function
1	-
2	Door ajar warning lamp
3	Rear differential lock mode
4	2WD mode
5	-
6	Centre differential lock mode
7	-
8	4WD indicator lamp
9
10	-
11	Input of front fog lamp indicator lamp
12	Input of parking brake switch and brake fluid level switch
13	Earth
14	-
15	Illumination (earth)
16	Illumination (power supply)
17	Brake warning lamp
18	SRS air bag warning lamp
19	ABS warning lamp
20	-
21	Input of engine coolant temperature gauge
22	Input of fuel gauge
23	Input of turn-signal lamp RH switch
24	Input of high beam switch

Mitsubishi part numbers of combination meters:

Part number	Description
8100B172	2008 AT 3.2D (KH0)
8100B176	2009-2010 AT 2.5D
8100B653	2010-2011 AT 2.5D
8100B739	2011-2012 AT 2.5D
8100B740	2011-2012 AT 2.5D ASC
8100C140	2012+ AT 2.5D ASC
8100C143	2012+ AT 2.5D ASC
8100B175	2009-2010 MT 2.5D
8100B635	2010-2011 MT 2.5D
8100B729	2011-2012 MT 2.5D
8100B730	2011-2012 MT 2.5D ASC
8100C124	2014+ MT 2.5D
8100C127	2012 MT 2.5D ASC
8100C105	2014 / L200 2.5AT

Connection to combination meter

Mitsubishi media 8701A053

Mitsubishi partnumber: 8701A053 (full documentation here).

Connector C-129

Pin number	Pin function
26	M-DATA
27	M-BUSY
32	-
33	UNKNOWN (L-GND)
34	M-CLOCK

Connector C-130

Pin number	Pin function
1	Rear door speaker RH (+)
2	Rear door speaker LH (+)
3	Antenna power (?)
4	-
5	Front door speaker LH (+)
6	Front door speaker RH (+)
7	Rear door speaker RH (-)
8	Rear door speaker LH (-)
9	-
10	IG1 power supply
11	Battery
12	Illumination (+)
13	Front door speaker LH (-)
14	Front door speaker RH (-)

Connector C-131

Only one pin - GND. It's in case of

RV Meter 8750A190 or 8750A347

Connector C-168

This connector part number:

• JAE MX34028SF1 - plastic case of connector
• JAE M34S75C4F1 - metall pins for connector

Pin number	Pin function
5	M-BUSY (Audio)
6	M-DATA (Audio) (M-BUS data signal)
7	CAN L (realy CAN H)
9	Input of fuel gauge
10	EX-TEMP (ambient temperature sensor signal)
11	ACC (ACC power supply)
12	+B (Battery)
13	VSS (Vehicle speed pulse signal)
14	GND (earth)
19	M-CLOCK (Audio) (M-BUS clock signal)
21	CAN H (realy CAN L)
23	GND – TEMP
25	ILL + (button illumination signal)
26	IG1 (IG1 power supply)

RV-Meter on NMPS'08 (grayscale screen)

Connector C-108 (RV-METER NMPS'08)

Terminal No.	Signal Symbol	DB-9 Pin
21 - 22	-	-
23	EX-TEMP (ambient temperature sensor signal)	1
24	ILL + (button illumination signal)	2
25	ACC (ACC power supply)	3
26	+B	4
27	VSS (Vehicle speed pulse signal)	5
28	GND (earth)	9
29 - 30	-	-
31	GND - TEMP	6
32	ILL GND (button illumination signal)	7
33	FUEL GAUGE	8
34 - 36	-	-

Connector C-109 (RV-METER NMPS'08)

Terminal No.	Signal Symbol
1 - 5	-
6	DATA (ETACS SWS data signal via CAN adapter)
7	M-DATA (Audio) (M-BUS data signal)
8	M-CLOCK (Audio) (M-BUS clock signal)
9 - 14	-
15	K (engine K-line signal via CAN adapter)
16	-
17	M-BUSY (Audio)
18	SHIELD-GND (Audio)
19 - 20	-

Connector C-110 (CAN ADAPTER NMPS'08)

Terminal No.	Signal Symbol
1	+B (realy ACC)
2	DATA (ETACS SWS data signal)
3	-
4	GND (earth)
5	CAN L
6	CAN H
7	-
8	K (engine K-line signal)

Connector on GPS modules

Connector on BCOMP11 module

DB-9 pinout:

Terminal No.	Signal Symbol
1	GND
2	CAN-L
3	CAN-H
4	AN1 (Analog buttons)
5	AN2
6	VCC (12V)
7	RX
8	TX
9	AN3